tolerance on resistance ratio

If the p99%,and the fiducially probability is under 95%,When the egg number per gram of sample is in 1601～1700、1701～1800、1801～1900 or 1901～2000,the admissible deviation number.

运用概率理论,针对目前生产上绝大多数批次的良卵率p 99%情况,在置信概率为95%下,样本卵粒数在1601~1700、1701~1800、1801~1900、1901~2000区间内时,给出了样本良卵数的容许偏差分别为16、17、17、18粒;当良卵率p在99%~90%其他区间时,也分别给出了不同克卵粒数情况下样本良卵数的容许偏差。

These requirements determine the permissible variation of the satellite orbit parameters.

飞行任务对卫星轨道提出指标要求,这些指标决定了卫星轨道参数的容许偏差范围。

acceptable deviation of controlled variable

控制变量的容许偏差

The difference between actual steady running tape speed, averaged over a period of 1 second or greater, and nominal tape speed, expressed as tolerance percentage on tape speed.

稳定在1秒钟以上的时间内的实际运行带速与正常带速之差，用带速的容许偏差的百分数表示。

The permissible deviation from a specified value of a structural dimension, often expressed as a percent.

允许变量容差结构长度上允许存在的偏离某一既定标准的误差，常常用百分数来表示

margin of error

最大容许误差;最大允许误差;误差界限;误差量

color tolerance computer

颜色容许误差计算机

bleed allowance

色浆渗化分线容许公差

an unacceptable level of inaccuracy

误差达无法容许的程度.

The film forgives errors in focusing.

这种胶卷容许调焦误差。

The maximum allowable misalignment of the coupling is0.02 mm.

靠背轮找正的最大允许偏差为0.02毫米。

Edge processing deviation should be allowed to meet the norms.

边缘加工允许偏差应符合规范的规定.

Quality of electric energy supply-Admissible deviation of supply voltage

GB12325-1990电能质量供电电压允许偏差

The net effect of biases on international comparisons is easily summarized.

偏差对国际比较的基本影响容易概括。

Incentive Compatibility,Transaction Cost and the Policy Running Deviation

激励相容、交易成本与政策运行偏差

Effect of capacitance deviation on the supercapacitor energy storage module and solutions

容量偏差对超级电容储能的影响及解决方案

Deviation should be allowed to comply with the norms. The shear machine error should be allowed to meet the norms.

气割的允许偏差应符合规范的规定.机械剪切的允许偏差应符合规范的规定.

maximum possible margin of population deviation

可容许的人口相差幅度上限

" Hot-rolled beam steel-Dimensions, shape, weight and tolerances"

GB/T706-1988热轧工字钢尺寸、外形、重量及允许偏差

" Hot-rolled channel steel-Dimensions, shape, weight and tolerances"

GB/T707-1988热轧槽钢尺寸、外形、重量及允许偏差