Pressureless Sintering

Preparation process of ZrB_2/B_4C ceramic composites by pressureless sintering based on mechanical mixing;

基于机械混合法无压烧结制备ZrB_2/B_4C陶瓷复合材料

Research on pressureless sintering of hexagonal boron nitride;

六方氮化硼无压烧结研究

Discussion on pressureless sintering of SiC ceramic;

SiC陶瓷无压烧结工艺探讨

In this paper,the ZrB_2-SiC ceramic matrix composites were prepared by pressless sintering with YAG as sintering additive.

以钇铝石榴石-YAG为烧结助剂,通过无压烧结制备了ZrB2-SiC复相陶瓷。

Zirconium diboride-silicon carbide (ZrB2-SiC) composites were prepared by pressless sintering with yttrium aluminum garnet (YAG) as sintering additive.

以钇铝石榴石(yttriumaluminumgarnet,YAG)为烧结助剂,通过无压烧结工艺制备了ZrB2-SiC复相陶瓷。

The mechanical properties and microstructure of silicon nitride ceramics with MgO-Al2O3-SiO2 as additives produced by pressless sintering were investigated by XRD, SEM, TEM, EDS, and HRTEM.

以MgO-Al2O3-SiO2为烧结助剂,借助XRD、SEM、TEM、EDS、HRTEM等手段,研究了无压烧结氮化硅陶瓷材料的力学性能和显微结构,着重探讨了材料制备工艺、力学性能和显微结构之间的关系,通过调整制备工艺改善材料微观结构以提高材料的力学性能。

With nanometer (75mol%Bi2O3+25mol%Y2O3) powder prepared by coprecipitation as raw material, the nanocrystalline Bi2O3-Y2O3 fast ionic conductor was fabricated through pressureless reactive sintering technique.

在T=600℃,t=2h无压反应烧结条件下,纳米晶Bi2O3-Y2O3 快离子导体材料的相对密度可达96％以上,并且微观结构致密均匀,很少有残留气孔和裂纹, 平均晶粒尺寸在100nm以下。

Based on the combined-stage sintering model,the MSC of α-Al2O3 is constructed during pressureless sintering at constant heating rates in a dilatometer.

主烧结曲线对于预测陶瓷的烧结行为非常有用,以主烧结曲线理论为基础,对亚微米级α-Al2O3(平均粒径为350nm)的恒速无压烧结行为进行了研究。

Based on the combined-stage sintering model, the master sintering curve (MSC) for the α-Al2O3 was constructed for pressureless sintering at constant heating rate in a dilatometer.

主烧结曲线对于预测陶瓷的烧结行为非常有用,以主烧结曲线理论为基础,对微米级α-Al2O3的恒速无压烧结行为进行了研究。

MgB2 bulks，using magnesium powder and boron powder as starting materials,were successfully synthesized by conventional pressureless sintering (PLS) and sparkplasma sintering (SPS) methods, and their microstructure and superconductivity werestudied.

以 Mg 粉和 B 粉为原料，用传统无压烧结方法和放电等离子烧结方法成功地制备出 MgB2块材，并研究了其显微结构和超导电性，比较了两种方法制备得到的样品的成分，密度和微观结构。

The Pressureless Sintering Behavior and Master Sintering Curve at Constant Heating Rate for Titania;

氧化钛恒速无压烧结行为及主烧结曲线研究

The Investigation on the Sintering Mechanism for α-Al_2O_3 under the Pressureless Sintering Condition at Constant Heating Rates;

α-Al_2O_3的恒速无压烧结机理研究

Pressureless Sintering of Ytterbia-Coated ZrB_2-SiC Ceramic Composites

包裹Yb_2O_3的ZrB_2-SiC复合材料无压烧结

Synthesis of Ti_3SiC_2-SiC Composites Bulk by Pressureless Sintering

无压烧结制备Ti_3SiC_2-SiC复合材料块体

Low Temperature Presureless Sintering Behavior of Hydroxyapatite Powders

羟基磷灰石粉体的低温无压烧结行为

Slip Casting and Pressureless Sintering of ZrB_2-SiC Ceramics

ZrB_2-SiC陶瓷的注浆成型与无压烧结

Fabrication of High Nb Containing TiAl Alloys by High-Energy Ball Milling and Pressureless Sintering

高能球磨与无压烧结制备高铌TiAl合金

Microstructures and Mechanical Properties of Pressureless Sintered Ca_3(PO_4)_2/Si_3N_4 Composite Ceramics

无压烧结Ca_3(PO_4)_2/Si_3N_4复合陶瓷的组织结构与性能

Preparation and characterization of CeO_2-ZrO_2-MoSi_2 composite by pressureless sintering

无压烧结CeO_2-ZrO_2-MoSi_2复合材料及其力学性能研究

Low-temperature Nonpressurized Sintering and Performance of High-purity Er_2O_3 Target Material

高纯Er_2O_3靶材的低温无压烧结及性能研究

Fabrication of Diopside/AlTiB Toughened and Reinforced Alumina Matrix Structural Ceramic Materials by Non-pressure Sintering Process

无压烧结制备透辉石/AlTiB增韧补强氧化铝基结构陶瓷材料

Fabrication of diopside toughened alumina matrix structural ceramic materials by pressureless sintering process

无压烧结制备透辉石增韧补强氧化铝基结构陶瓷材料

Pressureless Sintering Behavior and Working Mechanism at Constant Heating Rates for Alumina Doped with Rare Earth

稀土掺杂氧化铝恒速无压烧结行为及作用机理研究

Influence of CNT on Densification of Sm_2Zr_2O_7 Ceramics for Thermal Barrier Coatings by Pressureless Sintering

碳纳米管对Sm_2Zr_2O_7热障涂层陶瓷无压烧结致密化的影响

Study on Pressureless Vacuum Powders Sintering of NIB and IN738 for Bonding Repairing Superalloy

NIB与IN738混合粉末真空无压烧结连接修复高温合金

ULTRA-HIGH PRESSURE SINTER NANO-SiC CERAMIC

无烧结助剂SiC陶瓷的高压烧结研究

Density Sintering of LKNN Lead-free Piezoelectric Ceramics Doped With MgO

MgO掺杂LKNN无铅压电陶瓷的致密化烧结

Sintering properties of K_(0.5)Na_(0.5)NbO_3 lead-free piezoelectric ceramics

K_(0.5)Na_(0.5)NbO_3无铅压电陶瓷的烧结特性