squeezing degree

Our results show that the squeezing degree and squeezing direction of the output optical image can be controlled by the parametric image amplifier,namely,the increase or decrease of the squeezing degree and the change of the squeezing direction are dependent on the parameter selection of the parametric image amplifier.

结果表明:参量图像放大系统能够控制输出光学像的压缩度和压缩方向,即压缩度的增加与减小和压缩方向的改变决定于参量图像放大系统的参数选择。

Preparation of high compression strength polyacrylate/polysiloxane interpenetrating network hydrogel;

高压缩强度聚丙烯酸盐/聚硅氧烷互穿网络水凝胶的制备

The compression strength of pitch derived car.

将高温煤沥青和浸渍剂沥青在不同压力下炭化,在2500℃下对所得沥青炭进行石墨化处理;测试了所得沥青炭的体积密度、开孔率;利用扫描电子显微镜(SEM)观察了所得沥青炭的显微结构;利用XRD检测了所得沥青炭石墨化处理后的石墨化度;测试了所得沥青炭的压缩强度。

The structure,thermal stability,especially the effects of isothermal annealing on the microhardness and compression strength of this bulk metallic glass were investigated by X-ray diffraction,differential scanning calorimetry,microhardness and compression tests.

采用X射线衍射(XRD)、示差扫描量热(DSC)、显微硬度及压缩试验等方法研究了非晶合金的结构、热稳定性,特别是等温热处理对其显微硬度与压缩强度的影响。

3D fiber waviness model and prediction of compressive strength of stitched laminates;

缝合复合材料层板三维纤维弯曲模型及压缩强度预报

Computational modified model and experimental verification of compressive strength of the X-cor sandwich

X-cor夹层结构压缩强度模型改进与实验验证

Experimental study on uniaxial compressive strengths of artificial freshwater ice

人工淡水冰单轴压缩强度试验研究

In order to study the mechanical property of explosive crystals with different qualities,two recrystallized and a commercial grade RDX and HMX particles were selected and tested by compressive stiffness method.

分别选取三种不同品质的RDX和HMX颗粒集合体进行压缩刚度实验,并采用Kawakita压制模型对压制曲线进行拟合分析,得到评价晶体颗粒力学性能的具有模量量纲的常数。

We made TPA test on apple slices to investigate the influence of deformation rate and degree of compression on TPA test results.

本文简要介绍了TPA质构分析方法,具体阐述了TPA质构参数的含义,并对苹果片进行TPA测试,研究压缩速率和压缩程度对测试结果的影响。

Testing method for compressive(crushing)strength of high performance ceramics

GB/T8489-1987工程陶瓷压缩强度试验方法

Test method for crushing strength of porous ceramic

GB/T1964-1996多孔陶瓷压缩强度试验方法

testing method for compressive strength of hydraulic cement mortars

水凝水泥抗压缩强度测定方法

testing method for compressive strength of fire brick

耐火砖耐压缩强度试验方法

testing method for compressive strength of insulating fire bricks

绝热耐火砖耐压缩强度试验方法

Study on PBO Fiber Compress Strength Modification and Light Aging;

PBO纤维压缩强度改性及其光老化研究

Sintered metal materials--Determination of compression strength at room temperature

GB/T6525-1986烧结金属材料室温压缩强度的测定

paper and board--Compressive strength--Short span test

GB/T2679.10-1993纸和纸板短矩压缩强度的测定法

fine ceramics(advanced ceramics, advanced technical ceramics)-test method for compressive strength of monolithic ceramics at room temperature

细陶瓷-单块陶瓷常温耐压缩强度试验方法

Computational modified model and experimental verification of compressive strength of the X-cor sandwich

X-cor夹层结构压缩强度模型改进与实验验证

NUMERICAL ANALYSIS FOR SIZE EFFECT OF STRATIFIED ROCK MASS UNDER COMPRESSION

层状岩体压缩强度尺寸效应的数值分析

Similarly, adding BGE also conduced to the improvement of impact strength and slight decrease in compressive strength and modulus.

加入BGE后,材料的冲击强度提高,但是压缩强度和模量减小。

Effects of Silicon Carbide on the Cure Depth,Hardness and Compressive Strength of Composite Resin

碳化硅对复合树脂固化深度、硬度和压缩强度的影响

Structural Intensity of Piston Compressor

活塞压缩机结构强度

The Strength Fuzzy Reliability Design of the Helical Compression Spring;

螺旋压缩弹簧强度的模糊可靠度设计

Experimental investigation of compression speed influence on the compressive resistance of electrorheological fluids

压缩速度对电流变液抗压强度影响的实验研究

testing methods for strength properties of adhesives in shear by compression loading

胶粘剂压缩剪切强度试验方法

Preparation of Silicon Rubber with High Strenth and Low Permanent Compressing Disformation;

高强度低压缩永久变形硅橡胶的研制