DLR Driving Lamps Relay

The auto headlamp relay cannot be repaired and, if faulty or damaged, it must be replace

不能自动头灯继电器，如果有故障或损坏，必须更换它们。

BACK-UP LAMP RELAY CONNECTOR

备用车灯继电器接头

DISCONNECT THE COURTESY LAMP RELAY CONNECTOR.

断开上车照明灯继电器接头。＊＊

fluorescent tube starter-relay

日光灯管起动器-继电器

Install the headlamp or park lamp relay by aligning the relay terminals with the cavities in the junction block and pushing the relay firmly into place.

安装头灯或停车灯继电器，须将继电器端子对正接线盒中的插孔插紧。

TCM connector, Trans relay or relay connector

ＴＣＭ接头，变速继电器或继电器接头

KEY OFREINSTALL THE BACK-UP LAMP RELAY.

关闭开关。重新安装后上灯电路继电器。

TRANS CONTROL RELAY CONNECTOR

变速箱控制继电器接头

WITH THE DRB, ACTUATE DOOR UNLOCK AND OBSERVE THE TEST LIGHT.

用ＤＲＢ触发门开锁继电器并观察测试灯。

ABS warning lamp driver circuit open between the CAB and relay box

ＣＡＢ和继电器箱间的ＡＢＳ警示灯驱动电路断路

FROM THE TCM LINK CONNECTOR TO THE RELAY CONNECTOR

从ＴＣＭ连接接头到继电器接头。

NOTE: THE COURTESY LAMP RELAY IS LOCATED ABOVE THE BRAKE PEDAL.

注意：上车照明灯继电器被固定在杀车踏板上。

Design of Combination Relay Controlling Steering / Wiping / Rear Foglight

转向/刮水/后雾灯控制用组合继电器的设计

Remove relay from connector before testing.

在测试前，从接头拆卸继电器。

time delay relay

延时继电器时间继电器

MEASURE THE VOLTAGE AT TRS T3 SENSE CIRCUIT AT RELAY CONNECTOR.

测量位于继电器接头的ＴＲＳ Ｔ３感知电路的电压。

In this diagram, a single-pole normally open relay is controlling the connecction of the voltage source to the lamp.

在该图中，一个单刀常开继电器控制着电压源和照明灯之间的连接。

Analysis on Arcing Characteristics and Experiments of Electrical Contacts in Automobile Relays;

汽车继电器电触头燃弧特性分析及试验研究