rewind

Electromagnetic planar micromotors were produced using AZ4903 with high depth-width ratios and thicknesses of the planar micromotor s stator windings.

为满足电磁型平面微电机对定子绕组线圈的高深宽比及厚度要求,提出一种利用AZ4903光刻胶制作电磁平面微电机定子绕组的方法。

Preliminary reason analysis of looseness of main and auxiliary pole winding coils for traction motor

牵引电动机主、附极绕组线圈松动原因浅析

New Material Utilization for Soft Winding Electrical Machinery Stator Coil Winding Former

软绕组电机定子线圈绕线模新材料运用

transformer coil winding paper

变压器线圈缠绕用纸

Development of Impulse Test Device for the Inter-Turn Insulation of HV Electric Machine Coil;

高压电机线圈绕组匝间绝缘冲击试验设备的研制

The Coil End Complex Mode Structure Improvement of Hardware Motor Stator Windings Forming

硬绕组电动机定子成型线圈复形模端部结构改进

The teacher has made it clear that the coil must be wound this way .

教师已经讲明，线圈应这样绕。

Figure 34-1 is a sectional view of two closely wound coils of wire.

图34-1是两个密绕线圈的截面图。

Note: Close woundcoils will resonate at a slightly lower frequency.

（注：密绕的线圈将会谐振在稍低的频率。）

The iron with the wound coils on it is called an armature .

缠绕着线圈的铁心叫做电枢。

The successive coils are wound in alternate directions.

相邻的线圈是按交替的方向绕制的。

"This test checks for proper connection, impedance balance between the phases and minor or impending short circuits in the windings."

对于连接是否恰当、相位之间阻抗是否平衡和线圈绕组里的紧急短促小电流,也进行全面的检测。

divided conductor protectio

绕组支路断线保护装置

core, ceramic, for electrical windings or bobbins

金属陶瓷磁心,绕组或绕线架用

core of plastic insulating material, for electrical windings or bobbins

芯体,塑料绝缘材料制,绕组绕线架用

Route the thread in the order of A, B, and C, and then wind it round the bobbin several times.

按照A、B、c的顺序穿线，然后在梭芯上绕数圈线。

A magnet consisting essentially of a coil of insulated wire wrapped around a soft iron core that is magnetized only when current flows through the wire.

电磁体一种磁体，主要由绝缘线圈缠绕的一个软铁芯子组成，只有当电流通过线圈时芯子才被磁化

a circle that rolls around (inside or outside) another circle; generates an epicycloid or hypocycloid.

绕着另一个圆圈（里面或外面）滚转的圆圈；产生外摆线或内摆线。

In one way, primary and secondary coils are wound around the space.

有一种方法是把初级线圈和次级线圈绕在这个地方。